Arrowhead
Drive and Non-Drive Pulley Lagging is the solution,
in an application where rubber is the answer, to
help eliminate slippage, increase pulley life
and to improve production. A specialy
formulated combination of synthetic, natural,
and neoprene rubber compounds provides our
pulley lagging with excellent gripping strength
and abrasion resistance.
|
-
MSHA approved for mine use-
meets all requirements for flame resistant
solid products taken into mines. Acceptance
Marking No. MSHA IC -174/2
-
Increase Productivity
– by delivering increased traction
between the belt and pulley, and increasing
pulley life and reducing buildup.
-
Improved Belt Tracking
– due to the Arrowhead patterns self-cleaning
ability, which reduces material build up and
thereby eliminates the major source of
misalignment.
-
Superior Wear
-
ability in abrasive or highly wet or dry
applications as seen in below ground and above
ground mining.
-
Bonding Strength
– that is superior
to others, due to 3mm of our neoprene compound
vulcanized into bottom-side of the lagging.
-
Easy Installation
–
can be done
in place, on plant site, at your local
distributor or at the pulley manufacturer.
Each roll is ½” or ¾” thick x 10” wide by
21.3’ long. 300’ (90m) long rolls will
be available in January of 2006.
|
|
|
Drive and Non-Drive Rubber Pulley Lagging
|
|
Click for
Informational Charts on Arrowhead Drive and
Non-Drive Rubber Pulley
Lagging |
 |
Typical Arrowhead Rubber
Pulley Lagging Specifications |
|
|
Instructions for
Determining Total Number of Strips, Inches and
or Rolls Needed to Lag a Pulley |
|
|
Arrowhead Rubber Pulley
Lagging Taber Abrasion Tests |
|
|
Arrowhead Rubber Lagging
Cement Required Calculation |
|
|
Arrowhead
Rubber Pulley Lagging Part Numbers and
Descriptions |
|
|
|
 |
Arrowhead Rubber Pulley Lagging Brochure |
|
|
Arrowhead Rubber Pulley Lagging
Installation Instructions |
|
Return
to Main Manufactured Products Page
|
Arrowhead
Rubber
